Saturday, 25 November 2017

How to flash and download itel 1406 ROM or flash file

Download itel 1406 Stock ROM or firmware

itel 1406 rom or flash file


itel 1406 specifications
Model                 it1406
Android version 4.4.2; eng.zhangzixiao.20150710.164305; SDK19
CPU     4 cores; ARMv7 Processor rev 5 (v7l) sc8830; Max: 1300.0 MHz; Min: 768.0 MHz
Display      800 x 480; DPI: 240; Evaluated Size: 3.9"
Touch screen NOT multitouch 1 point
GPU    Mali-400 MP; ARM; OpenGL ES-CM 1.1; OpenGL ES 2.0
RAM    1024 MB
Flash    8 GB (7.047 GB actual); 0.293 GB; 8 GB (7.211 GB actual) (see memory map tab)
Communications Phone GSM; Net: HSPAP
WiFi                                 sprdwl
USB Host                Yes
Bluetooth                        Yes
GPS                        Yes


Caution: 
We recommend you backup your itel or SPD android phone with Miracle box in .bin format before flashing.
Ensure you read all the instructions careful before you start flashing your SPD android phone. zamdtek is not responsible for any bricked/dead spd android phone.
Look at the SPD android you have, compare it with the picture of the ROM/firmware you  are about to download.
You must download the exact ROM or file or .bin of your SPD android phone, before you load the file for flashing operation.
Flashing a wrong ROM or file or .bin file will not only kill your SPD android phone but will make it not to be detected by any computer.

itel 1406 Stock ROM or Flash file




If you encounter 
spd sc7715 flashing failed incomplete partition learn how to fix it here


What you need to flash itel SPD android phones


You need a working laptop or good PC that has no virus.
Download and install SPD Drivers on your PC.
Download and install Research Download or Upgrade download on your PC. We recommend Research Download for smaller itel android phones.
Download and install Miracle Box.
Download and save the SPD android flash file or ROM.

Learn How to flash SPD with Research Download or Upgrade download here

Learn how to use Miracle Box and flash SPD android phone

 Steps

  1. Get a working the same type of SPD android phone.

2.            Connect your Miracle box to the computer.

3.            Get a working USB cable and working brain.

4.            Open the Miracle box interface.

5.            Select Read file.

6.            Hold Up of the android phone.

7.            Connect the phone to USB and allow it to read the flash file.

8.            Save the file to a location where you can remember.

9.            Bring the bricked SPD phone do step 6.

10.         Connect the phone to USB and select write file.

Allow the phone to write the file finish.

No comments:

Post a Comment

Your comments helps us to improve & others to learn